TMI Colourful Decorative Acid Free Tempered Glass Panels

Wear Resistance TMI Decorative Tempered Glass For Home Appliance Panel

Description of decorative tempered glass:

The surface coatings of opaque materials such as plastics and metals are all external finishing, and the visual effect has no sense of thickness. Moreover, the coating is in direct contact with the outside world, which has disadvantages in terms of aging resistance, friction resistance, scratch resistance, etc., and is not easy to clean, and is directly eroded by acids, alkalis, salts, solvents and other gases or liquids. The toughened color crystal glass can overcome these shortcomings.

Features of Decorative Tempered Glass

1. During the production process, due to that TMI is made with high-temperature photosensitive material, and the pattern is fused with glass after tempering process. The surface of TMI product has the characteristics of scratch - proof and never fall off.
2. High-quality float glass is selected as the base material, which can avoid the radiation of the natural marble. The product is green, environmental and safe. TMI products are not only used in home appliances, but also the best choice for furniture.

Application of Decorative Tempered Glass

Decorative tempered glass is widely used in refrigerator , air conditioner , microwe oven , washing machine etc.

Decorative Tempered Glass Producing
Unlike annealed glass or what we know as “ordinary” glass, tempered glass does not break into large jagged shards that can cause serious injuries. Instead, it breaks into smaller granular pieces that are less likely to cause harm. This is why tempered glass is used in passenger vehicle windows, refrigerator trays, shower enclosures, microwave ovens, and other things we use on a regular basis.
Tempered glass is also much stronger than annealed glass. It undergoes a complex manufacturing process that toughens it both physically and thermally.

TMI Adhension Test on Decorative Tempered Glass

Adhesion, Preheat 5 pieces in the environment of (100 ± 2) ℃ for 0.5h, and then naturally cool to room temperature. Select three non adjacent areas on each piece of workpiece, at least one 10 mm away from the edge, with a spacing of 1 mm and a 10 mm * 20 mm network grid (all cuts should be made to the surface of the substrate). After cleaning the surface paint layer with soft towel, paste the surface with 3m610 transparent tape, rub the tape with finger tip, and fully contact the coating color seen through the tape. Within 5min after sticking the adhesive tape, hold the hanging end of the tape, and tear off the adhesive tape steadily at an angle of 90 ° for 100 times within 0.5s ~ 1s. The coating on the front of the sample shall not fall off.

FAQ

1. Q: Could you provide the sample for us to verify the quality?
A: Yes, we can provide the glass for you verify the quality if you would like to undertake the freight cost.
2. Q: What's the cut hole effect?
A: It depends on different thickness and for thick glass; we usually use water jet + CNC.
For thin glass, we use CNC for cut hole to make sure no breakage chips exist from hole edge.
3.Q: Is irregular shape glass available?
A: No problem because we will use shape cutting machine + CNC to make sure about the quality.
4.Q: How's the silk print effect?
A: GL received lots of praise in silk print quality base on import paints + auto silk print machine + dust free room
Available in high temperature silk print(The paint melt into glass) and low temperature paint(Pass adhesion test).